- Business
- Link
Silicon carbide drying project
Project Overview:
Silicon carbide (SiC) is made of quartz sand, petroleum coke (or coal), wood chips as raw materials through the resistance furnace high temperature smelting. Silicon carbide also has rare minerals in nature, mozzanite. Silicon carbide, also known as carbon silica. In the contemporary C, N, B and other non-oxide high-tech refractory materials, silicon carbide for the most widely used, the most economical one. Can be called gold sand or refractory sand. At present, China's industrial production of silicon carbide is divided into black silicon carbide and green silicon carbide two, are hexagonal crystal, the specific gravity of 3.20 ~ 3.25, micro hardness of 2840 ~ 3320kg / mm2.
Equipment Overview:Silicon carbide (SiC) is made of quartz sand, petroleum coke (or coal), wood chips as raw materials through the resistance furnace high temperature smelting. Silicon carbide also has rare minerals in nature, mozzanite.
Silicon carbide drying production line is my company to overcome the static dry low efficiency, high consumption and research and development of new efficient fluidized drying equipment. The machine in the design process fully integrated with the air drying and other characteristics of dry flow, avoid weaknesses, so that the machine has a reasonable process structure and superior performance, the real flow of dry low consumption and high efficiency goals.
The scope of application of this machine is extremely wide, can be used for silicon carbide, black silicon carbide, green carbon silicon, black carbon silicon powder, green silicon carbide powder, foam ceramic silicon carbide, refractory silicon carbide and other small proportion of fine powder material drying. Equipment, high thermal efficiency, low energy consumption, small footprint, simple configuration, easy operation and control.
working principle:
Hot air from the inlet at the appropriate jet speed from the bottom of the dryer into the mixing crushing drying room, the material strong shear, blowing, rotating, so the material by centrifugation, shear, collision, friction and micro-granulation, Enhanced mass transfer heat transfer. At the bottom of the dryer, the larger and heavier particles are mechanically broken under the action of a stirrer, the moisture content is low, the particles with smaller particle size are entrained by the rotating air stream and further dried during the ascending process. For the rotation flow, the solid inertia is greater than the gas phase, the relative speed between the two phases of solid gas is large, and the heat transfer effect between the two phases is strengthened.
Engineering advantages:
1, professional and strong, large amount of processing, drying rate, the material after the atomization by the surface area greatly increased, in a vacuum state, the drying time greatly reduced. 2, the device structure is simple, no wearing parts, low maintenance costs. 3, simple and stable operation, easy control, can achieve intelligent operations. 4, the use of different boiling point temperature, to achieve liquid separation. 5, the use of non-standard design of the atomizer, atomization, separation effect is good. 6, set the chemical reaction, dry and one, one time to complete the reaction, dry, optimize the equipment performance.
- 2017-03-27 > Jiayou dry disc dry successfully shipped
- 2017-03-06 > Analysis on the Application of Eight Kinds of Drying Equipment in Chemical Industry
- 2017-02-12 > Application of Spray Dry Desulphurization Technology in Protecting Ecological Environment
- 2017-01-17 > Comparison of Powder Yield Rate of Special Extract and High - speed Spray Dryer
- 2016-12-19 > Belt dryer in the course of the use of common faults and maintenance
- 2016-11-23 > Application Range and Type Selection of Belt Dryer
- 2016-10-17 > Development Status of High Efficiency Mixed Granulator for Calcium Carbonate Industry
- 2016-09-27 > Safe use of hot air circulation oven and four points of attention
- 2016-08-06 > Rice dryer market will also be a new trend
- 2016-07-05 > Four Process Design Methods of Rotating Flash Dryer